|
Just
as its mother company, National Steel, used all its resources to
stay productive, so did the company's golf club, Williams Country
Club. In Weirton, W.Va., the local economy -- and the well-being
of Williams CC -- was dictated by the steel mills, especially
National Steel's Weirton division. As the club followed the
company's path, it was eventually forced to focus on only basic
needs. But years later, with careful planning and a supportive
membership, the club's resurrection began.
Willliams has a long history,
dating to 1931. National Steel owners wanted to build a course
with a country-club atmosphere. They wanted a place where they
could entertain customers, a place modeled after the famed Oakmont
Country Club. National hired Oakmont's superintendent, Emil
Loeffier, to look over a site in Weirton, sketch a design and
start construction. Loeffier remained busy with his duties at
Oakmont, so his brother Arch took over at Williams, and five years
later the course opened for play.
Williams CC prospered for many
years and was the playground for National Steel and its clients.
However, as the saying goes, all good things must come to an end.
When the prosperity associated with steel ended, National got out
of the steel business. It sold its mill to the employees and sold
the country club to the membership in 1982.
For the next 10 years, the
objective of the course was simply to keep its head above water.
But there was an obvious need for renovation.
After
three years of renovations, the final six holes to be completed
opened for play on April 1. Additions, such as new bunkers around
the No. 14 green, were part of the course's facelift.
 |
First things
first
I came to Williams in the fall
of 1992. At that time the club was beginning to show signs of new
prosperity, but the course needed to upgrade if it was going to
survive. The first priority was to assess just how much work would
be required.
The largest immediate obstacle was
solving an existing problem with black layer. Black layer is
caused by gas buildup under the green surface. It is brought on by
anaerobic conditions and heat in the summer months. Black layer
causes thin, blotchy greens for up to 90 days. We faced the
problem by overseeding late in the summer.
However, members were still upset
by this particular problem, so an informative meeting was
scheduled. Thomas Watschke, Ph.D., professor of turfgrass science
at Penn State University, was asked to review our situation and
discuss a solution with our green committee. Watschke confirmed
that the program we already had in place, combined with a vigorous
aerification plan (20 times in five years) and the pruning or
removal of all adjacent trees, would solve the black layer
problem.
At the same, we sent out a survey
to members to get their opinions on subjects such as green and tee
renovation, course conditions, bunkers and the possibility of a
water hazard. What the survey results showed was that we had a
divided club membership. Almost all responses were split in half:
50 percent wanted renovation, 50 percent didn't; 50 percent liked
the course in its current state, 50 percent wanted change. The
only item that a majority agreed on was the addition of a water
hazard.
From the survey results, the board
decided the plan of action should be, first, to solve the green
problem, and then they would OK renovations of the landscape,
including bunkers, fairway bunkers and perhaps a lake or pond.
With
overwhelmingly positive feedback from the club membership, the
renovation plan was changed to include a lake, the course's first
water hazard. CGCS Dan Houk and his crew added a 75-foot stream
and waterfall to the 12th hole as well.
 |
Planning for
action
Solving the black layer
problem was a slow process, but each summer the condition appeared
less and less. Looking toward the future, the club hired a course
architect, Jeff Myers of J.C.M. Group. Myers had grown up in the
area and was excited about restoring the once-proud country club.
We determined that the course had
many problems. Green surrounds had every type of grass that grew
in the area; the bunker surrounds were not uniform in sand or
style; the lakes became lost after fall rains, and they had sand
up their slopes that created a maintenance nightmare. The par 4s
were almost all the same: short with minimum fairway bunkers and
not very challenging.
The renovation architect designed
a master plan, with the hope that after five years the greens
would once again be back to excellent condition. All the greens
surrounds were redesigned, and fairway bunker complexes were added
in strategic places.
Survival of the greens during the
'96 season allowed us to put our plans in place. We accepted
renovation bids and presented everything to the membership. With
money always a factor, it was decided to carry out the project
over three years. This timeline allowed project funding to come
from the regular cash flow without an assessment. It also provided
for the renovation of six holes at a time, allowing work to be
done in October and November when play is minimal and green fees
and golf car income would not be affected.
The board approved this approach
and the hiring of Aspen Corp. of Daniels, W.Va., to do the
renovation work.
Aspen
Corp. of Daniels, Va., worked on the renovation two holes at a
time. Here they are working on No. 2.
 |
Two at a time
Renovation of the first six
holes started in October 1997. The holes with the most problems
were the first to be renovated. The 12 remaining holes were
reduced to nine holes from October to April. The renovation was
completed within 60 days, but the holes remained closed until
April.
The renovation process involved
two holes at a time. Following a hole design created by the
architect, Aspen Corp. stripped all green surrounds and disposed
of all sod and sand from the old bunkers. The putting green
surface was the only area left untouched. Following the blueprint,
the company formed new surrounds, cut out bunkers, installed
drainage systems and added sand to bunkers. The entire green
surround was sodded, and bluegrass and ryegrass seeded.
Williams
CC's No. 2 after completion in December 1998.
 |
Fairway bunker complexes were made
with each green surround, and the process continued from hole to
hole and repeated over the next two years into late fall.
Watery reward
The final six holes offered an
additional challenge that was very rewarding for me and my crew.
The board's feedback from the membership was so positive that the
design on the No. 12 hole was changed to include a lake.
To add the lake, we first took
soil samples to make sure the on-site materials could be used to
form the dam. An engineer who specialized in dams was brought in
to approve the design. A local company, James White Construction,
was awarded the contract to work with Aspen Corp. on the new
signature hole.
For me, this stage of the project
was especially rewarding because I was in charge of adding a
75-foot stream and waterfall. The waterfall/stream runs from the
lake to a smaller pond used for recycling water.
The renovation project was
completed in December when the last piece of sod was installed.
April 1 was the opening day for the final six, and the renovations
met with overwhelming enthusiasm from the membership.
The renovation has been so
successful that our club now has a waiting list for membership for
the first time in years. We are making further plans for a new
irrigation system. Although we want to complete an irrigation
change in one season, we are still following the sound practices
we used for the renovation. We've hired an irrigation consultant
and will involve the general membership.
I know a lot of golf facilities
need renovation. We found that a well-planned approach works best
-- even if it's over a three-year period.
Dan Houk is CGCS at Williams
CC in Weirton, W.Va., and a seven-year GCSAA member.
|